How to Create Your Own Dog Mask – The Basics

In this article we’re going to examine how to make your own dog mask. We’ll cover the basics and then go on to look at some of the more advanced tips and tricks which you can use.

For those who have a dog that likes to bark, and especially if your dog loves to play in the backyard and other regions of the house, you will need to get them some special dog protection.

Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the setup which will look a little scary at first, but it is actually quite simple. All you’ve got to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t just cut a rectangular shape from the cardboard, so you will have to cut around the edge of the mask so that you get something which looks like a cone. The main thing here is to be realistic with what kind of paper plate that you’re using.

Then you’ll need to wrap the cardboard around the edges of the paper plate, making certain there is a good seal between the two pieces so you can make certain that nothing will leak when you put the mask on. Make sure the edges are cut so that the edges are not sharp, as this may damage the edges of the mask.

Glue it on! The next step involves using some paint. You ought to spray the paint over the cardboard, making certain it runs smoothly and evenly across the entire mask. You will want to start with one side of the mask first, so that you can work your way round it before moving onto the other side. The paint has to be slightly thicker than the cardboard, and it is best that you leave about one-third of an inch of paint on the edges so that it runs over the cardboard.

Don’t worry too much about the paint getting stuck into your mask. It’s easy to eliminate it later, and it will leave you with a wonderful finished mask to show off to everybody! It’s also a good idea to wipe away any excess paint after you’re done, so you don’t wind up with smudges or smears on your dog.

Then it’s time to glue the mask on your dog’s head. First you will need to make sure that you get a secure fit between the mask and your dog’s head. Once you’ve made sure that it’s secure, then you can begin to glue the mask on the dog’s face. Take the piece of cardboard that is used for the base of the mask and then fold it over. Make sure that it’s quite strong and then use your hands to ensure the cardboard down in place.

Keep your site hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds till you’ve got the mask snugged firmly onto the face of your dog. Do not make the folds too large or else it might look messy. As soon as you’ve completed this, you can then take out the mask and then attach the cardboard ears. And attach the other area of the mask on the dog. Be sure that the ears are level and make certain it is not too short or long as this will cause some issues with the mask slipping off the dog’s face.

If you’re using a dog mask because your dog protection, you’ll need to do some sanding to be certain it’s secure on your dog. You can do it by sanding off any excess paper which might have been removed from your mask.

Leave a Reply

Your email address will not be published. Required fields are marked *